Administering Data Domain and DD Boost
Data Domain system administration
This topic discusses the following subtopics:
Restricting export permissions to DD Boost
To delete all clients from the DD Boost clients list, enter:
Optionally, to delete all clients previously added and reset the DD Boost clients list, enter:
To view the DD Boost clients list, enter:
Notes:
Modifying an interface group
After the interface group is set up, you can add or delete interfaces from the group. The following example shows how to remove an interface from the configured interface group on the EMC® Data Domain® system.
Remove the interface from the group on Data Domain system:
If you use the net command to change the interface, such as enabling an interface that is configured for ifgroup, run the ddboost show connections command to update the load balancing view. This updating allows the ifgroup to use the interface. For more information about the ddboost show connections command, see Show connections.
Removing advanced load balancing and link failover configuration
The following example illustrates removing a configured interface group on the EMC® Data Domain® system.
Setting network timeouts
Backup and restore jobs often take a long time to complete. Although the EMC® Data Domain® Boost (DD Boost™) Library can recover from temporary network interruptions, the operating system on vRanger might terminate a job prematurely if vRanger timeouts are set too low.
EMC recommends setting timeouts to at least 30 minutes (1800 seconds).
NOTE: After losing a network connection, administrators should issue the ddboost reset stats command to clear job connections.
© ALL RIGHTS RESERVED. 이용 약관 개인정보 보호정책 Cookie Preference Center