Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault 12.4 - CLI Reference Guide

Introduction Getting started Using the command-line utilities Using the nvreport utility

nvclientaccess

Grants access to specified NetVault Backup Clients.

-client or -clients

Specifies the names of NetVault Backup Clients to which access is granted.

-tdclients

Specifies the name of the Teradata DBS. You can use this option to grant access to all added clients.

-password

Specifies NetVault Backup password of the client. This option is required if security is enabled on the client.

nvclientadd

Adds a single NetVault Backup Client to the server. You must run this utility on the NetVault Backup Server.

-client

Specifies NetVault Backup name of the client that you want to add.

-clientip

Specifies IP Address of the NetVault Backup Client that you want to add.

-clientgroup

Specifies the name of the client group to which you want to add the client. Verify that the client group is created before you add the client.

-password

Specifies NetVault Backup password of the client. This option is required if security is enabled on the client.

-timeout

Specifies the amount of time NetVault Backup waits for the client to approve the “add” request. The timeout value is specified in minutes. If a client cannot be added within the specified period, an error message is displayed

-version

Displays build date of the NetVault Backup distribution installed on the machine.

To locate a client that is unavailable, use the nvclientlist -find <ipaddress> command. For more information, see nvclientlist.

nvclientlist

Performs the following functions:

Table 6. nvclientlist

-current

Lists clients that are currently added to the NetVault Backup Server.

-available

Lists available NetVault Backup machines that can be added as clients.

-name

Specifies NetVault Backup name of the client that you want to locate.

-find

Specifies the resolvable name or IP address of the machine that you want to locate.

-version

Displays build date of the NetVault Backup distribution installed on the machine.

nvclientname

Allows you to rename a NetVault Backup Client. You cannot use this utility to change the name of a NetVault Backup Server.

Table 7. nvclientname

-clientname

Specifies the new NetVault Backup name for the client.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation