Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault 12.4 - CLI Reference Guide

Introduction Getting started Using the command-line utilities Using the nvreport utility

nvsendmail

Sends an email to the specified address.

Table 87. nvsendmail

-d

Specifies the email address of the intended recipient.

-r

Specifies the actual name of the intended recipient.

-s

Specifies the subject line of the email.

-f

Specifies the email message file that you want to send.

-a

Specifies the attachment that you want to send. Provide the full path for the attachment file.

-m

Forces mime format.

-n

Specifies notification mode in which the necessary parameters are obtained from the host environment.

nvsendopmsg

Sends an operator message.

Table 88. nvsendopmsg

-n

Sends notification from environment variables.

-test

Sends a test message.

nvtrace

Use this utility to perform the following tasks:

Table 89. nvtrace

--status

Displays whether tracing is enabled or disabled on the specified machine. You can use the following option with --status:

--client: Specifies the NetVault Backup Client. If the client name is not specified, the status of tracing on the server is displayed.

--enable

Enables tracing on the specified machine. You can use the following options with ‑‑enable:

--client: Specifies the NetVault Backup Client. If the client name is not specified, tracing is enabled on the NetVault Backup Server.
--startat: Specifies the date and time when tracing should be started on the machine. The format for specifying this option is YYYYMMDDHHMMSS.
--stopat: Specifies the date and time when tracing should be stopped on the machine. The format for specifying this option is YYYYMMDDHHMMSS.
You can omit the --startat and --stopat options to start tracing immediately.
--process: Specifies the process for which trace files are required. You can provide a comma-separated list of process ID numbers to generate trace files for the specified processes.

--disable

Disables tracing on the specified machine. You can use the following option with ‑‑disable:

--client: Specifies the NetVault Backup Client. If the client name is not specified, tracing is disabled on the server.

Using the nvreport utility

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation