Chatee ahora con Soporte
Chat con el soporte

Diagnostic Manager 5.0.1 - Installation Guide

Component Analysis Solution

The Metalogix Diagnostic Manager Component Analysis solution helps the Collection Service gather data about the page load times, the solution load times, ULS logging, and other information for SharePoint on-premises farms.  The Component Analysis Solution uses a separate installer, which is itself installed by the Metalogix Diagnostic Manager product component installer.  You can install the Component Analysis solution on any Web front end in your farm.  As with other solutions, SharePoint automatically replicates it to the other WFEs in your farm.

 

System Requirements

You can install  Metalogix Diagnostic Manager on any computer that meets or exceeds the hardware, software, and permission requirements. When you install multiple components on a single host computer, the computer should meet or exceed all of the requirements for the components.

Consider the following requirements when you install  Metalogix Diagnostic Manager in a typical environment.

·Hardware Requirements

·Software Requirements

·Permission Requirements

 

Hardware Requirements

Metalogix Diagnostic Manager requires the following hardware on any computer that hosts a component.

Hardware Type

Requirement

CPU

2 GHz

Memory

1 GB

Hard Drive Space

200 MB total for all components

 

Software Requirements

Metalogix Diagnostic Manager components have the following general software requirements, as well as specific requirements outlined in the following sections. If a service pack is not specified, a service pack is not required for that version of the software.

Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación