Replication between two ESX i hosts fail with the error message: "Device reconfiguration has not occurred yet"
This error is seen with vRanger 5.2.3 build. If the vRanger Virtual Appliance is not yet installed or configured on the source and/or target hosts, then one of the errors you may see is: Error Message: Device reconfiguration has not occurred yet.
Follow the Configuring the Virtual Appliance section of the vRanger 5.2.3 Installation Guide http://www.quest.com/Quest_Site_Assets/PDF/vRanger-Install-Guide.pdf, to properly install and configure the Virtual Appliance on both your source ESX(i) host and your target ESX(i) host.
Note: The VA is still required if one of the two host is ESXi.
© 2021 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Terms of Use Privacy