If your Toad Data Point is 64-bit then do the following:
1) Close Toad Data Point.
2) Go to the following path C:\Program Files\Quest Software\Toad Data Point 5.2
3) Locate the file named “Toad.exe.config”
4) Replace the existing file with the new "Toad.exe.config" file for 64bits from this KB article.
5) Open Toad Data Point.
6) Verify results.
If your Toad Data Point is 32-bit then do the following:
1) Close Toad Data Point.
2) Go to the following path C:\Program Files (x86)\Quest Software\Toad Data Point 5.2
3) Locate the file named “Toad.exe.config”
4) Replace the existing file with the new "Toad.exe.config" file for 32bits from this KB article.
5) Open Toad Data Point.
6) Verify results.
© ALL RIGHTS RESERVED. Feedback Terms of Use Privacy Cookie Preference Center