Initializing the DR Series
Before you can start using the DR Series system GUI for the first time, you must properly initialize the system. To initialize the DR Series system, complete the following:
This wizard lets you configure the following network settings to complete a first-time initialization of your system:
Configuring local console connections
To configure a local console connection, you must make the following two back chassis cable connections:
You are now ready to perform initialization using the DR Series system CLI login process.
Configuring the iDRAC connection
The iDRAC connection requires a network connection between the integrated Quest Remote Access Control (iDRAC) management port on the DR Series system and another computer running the iDRAC remote console session in a supported browser. The iDRAC provides remote console redirection, power control, and the out-of-band (OOB) system management functions for the DR Series system. iDRAC connections are configured using console redirection and the iDRAC6/7 web interface. The login values you can use for making iDRAC connections are:
When the Quest DR Series System splash screen is displayed, you are ready to begin initialization using the DR Series system CLI login process.
Logging in and initializing the DR Series
Use the DR Series system CLI and the Initial System Configuration Wizard to log in to and initialize the system. After completing a local console or iDRAC connection, log in to the DR Series system CLI:
|At the login as:
prompt, type administrator
, and press Enter
|At the administrator@<system_name> password:
prompt, type the default administrator password, St0r@ge!
, and press Enter
When completed, a successful initialization message is displayed.
You are now ready to log in to the system using the DR Series system GUI.