• |
Launching a restore from the Rapid Recovery Core Console. For more information, see Launching a bare metal restore for Linux. |
• |
You can launch the restore from the command line using the local_mount utility, or you can launch the restore from the Rapid Recovery Core Console. If restoring using the user interface, you must first mount the partitions.
Managing Linux partitions is a step in Performing a bare metal restore for Linux machines.
You can perform the following tasks:
This task is a step in Performing a bare metal restore for Linux machines. It is part of the process for Managing Linux partitions.
2. |
From the command line, enter the following command and then press Enter to change privileges to run as administrator and then list existing disk partitions: |
A list of all volumes appears.
6. |
To specify partition number, enter the partition number and then press Enter. For example, to specify partition 1, type 1 and then press Enter. |
7. |
For example, to allocate 500 M for the boot partition, type the following and then press Enter:
10. |
To assign a bootable flag for the appropriate partition, type the number of the partition and then press Enter. For example, to assign a bootable flag for partition 1, type 1 and then press Enter. |
For all other scenarios, you do not need to format partitions as described in this topic.
This task is a step in Performing a bare metal restore for Linux machines. It is part of the process for Managing Linux partitions.
2. |
From the command line, enter the following command and then press Enter to change privileges to run as administrator and then list existing disk partitions: |
© ALL RIGHTS RESERVED. Feedback Terms of Use Privacy Cookie Preference Center