The forcechecksum command lets you force an integrity check of any Exchange Message Databases (MDBs) present on the specified recovery point or points. When you force a checksum check, the command begins immediately.
The usage for the command is as follows:
The following table describes the options available for the forcechecksum command:
Protected machine against which to perform the checksum check. | |
Perform a checksum check for recovery points with numbers 5 and 7:
The usage for the command is as follows:
The following table describes the options available for the forcelogtruncation command:
Protected machine against which to perform log file truncation. |
Force log truncation for a protected server:
Use the forcemount command to conduct an one-time recovery point mountability check. This determines whether or not the specified recovery point or recovery points can be mounted and used to restore backed up data. You must list either one or more specific recovery points on which to conduct the check, or a time range during which the recovery points were created.
The usage for the command is as follows:
The following table describes the options available for the forcemount command:
Protected machine against which to perform a mountability check. | |
Perform mountability checks for recovery points with numbers 5 and 7:
Use the forcereplication command to force a one-time transfer of replicated data from the source core to the target core. You can replicate one specific protected server or replicate all protected servers. The protected servers must be already configured for replication.
The usage for the command is as follows:
The following table describes the options available for the forcereplication command:
Host name of the target core against which replication should be forced. | |
Force replication for all machines being replicated to the target core. |
Force replication for a protected server on a specific target core:
© 2023 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Terms of Use Privacy