Use the createrepository command to create a new DVM repository on a local machine or on a shared location.
The usage for the command when creating a DVM repository is as follows:
The following table describes the options available for the createrepository command:
Create a DVM repository at a local location:
Create a DVM repository at a share location:
Use the createtieredrepository command to create a tiering repository on a DR appliance.
The usage for the command when creating a tiering repository is as follows:
The following table describes the options available for the createtieredrepository command:
Create a tiered repository at a local location:
The usage for the command when creating a DVM repository is as follows:
The following table describes the options available for the dedupcacheconfig command:
Set primary deduplication cache location and deduplication cache size:
Set secondary and metadata deduplication location:
Restore default deduplication configuration:
The usage for the command is as follows:
The following table describes the options available for the DeleteReplication command:
| |||
| |||
Specify which recovery points, if any, of the replicated machine that you want to remove. |
Delete all incoming and all outgoing replications:
Delete two outgoing replications with all machines:
Delete one protected machine from incoming replication and delete recovery points:
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Terms of Use Privacy Cookie Preference Center