Chat now with support
Chat with Support

ChangeBASE 6.2.2 - Prerequisites and Getting Started Guide

Hypervisor Setup

To set up each Hypervisors (up to a maximum of 5)

  1. Click New.
  2. From the Hypervisor drop-down, make the required selection from Hyper-V, VMware Server (for VMware ESX), or VMware Workstation (Shared VMs).

Important: If you are using VMware Workstation (Shared VMs), then, as the name implies, all Virtual Machines have to be shared. This means that remote users can use their VMware Workstation to access shared virtual machines which are running on the same machine as the ChangeBASE service. Refer to Sharing Virtual Machines on VMware Workstation.

  1. In the Server IP field, enter the server name, or, if you are running VMware Workstation or VMware Server in Shared Mode, enter the IP address (as opposed to the name) of the machine running VMware Workstation or VMware Server.

Important: If you changed the TCP port that VMware Workstation or VMware Server uses for the shared Virtual Machines, then be sure to add this after the IP address (for example, add :123, where this is the port number). Refer to Sharing Virtual Machines on VMware Workstation.

  1. Enter your server Username and Password.
  2. Click Test Connection to verify that you can connect to the Hypervisor.
  3. Select Save to preserve your changes.

  1. Repeat the procedure as required to set up further Hypervisors.
Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating