cartridge is now detected as full (4047254)

Number of lives for cleaning slots goes down to 0 ior a much lower number than initially after only one cleaning cycle is run.

This is usually caused by a library requiring 'Generic cleaning' to be set in the cleaning config tab in device management where this has not been done.

If the configuration is left as it is and 'generic cleaning' is now selected it may be seen that the number of cleaning cycles remaining goes up again but not to the level it should be.

The best solution would be to remove the library from device management, readd it and then reconfigure the cleaning slot ensuring that 'Generic Cleaning' is selected from the start