The OCS/Lync Default Gathering does not run all of the required tasks (4236284)

Chat now with support

Return

Feedback Submitted

Did this article solve an issue for you?

Select Rating

Title

The OCS/Lync Default Gathering does not run all of the required tasks
Description

After configuring and running the OCS/Lync Default gathering for the first time only a couple of the required tasks run and the reports do not contain any data.
Cause

Some of the OCS/Lync dll files did not get registered properly during installation of the Report Pack
Resolution
1. Close the MessageStats Console
2. Stop the Quest MessageStats Scheduler Service
3. Navigate to the MessageStats installation directory (C:\Program Files (x86)\Quest Software\MessageStats)
4. Backup the gsc.xml file and then delete it from the directory
5. Open an elevated command prompt and navigate to the OCS directory (C:\Program Files (x86)\Quest Software\MessageStats\Report Packs\OCS)
6. Register each dll file found in the directory by running the command regsvr32 <nameOfdllFile>
  Note: You may get the following error for some of the dll files: "The module <nameOfdllFile> was loaded but the entry-point DllRegisterServer was not found. Make sure that <nameOfdllFile> is a valid DLL or OCX file and then try again" This can be ignored. Continue to run regsvr32 against all of the dll files
7. Restart the Scheduler service
8. Run your OCS/Lync gathering

Feedback Submitted

Did this article solve an issue for you?

Select Rating

Title