Chat now with support
지원 담당자와 채팅

NetVault Backup Plug-in for SnapMirror to Tape 10.0.5 - User Guide

Upgrading the plug-in

To upgrade the plug-in, follow the steps in the section Installing the plug-in. You can perform an upgrade installation without removing the current version of the plug-in.

Removing the plug-in

2
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage.
3
In the Installed Plug-ins table, select NDMP SnapMirror to Tape Plugin, and click the Remove Plugin button ().

Configuring the plug-in

Prerequisites

Connect the backup devices: Depending on the Data Transfer Model that you are using, connect the backup device to the NetVault Backup Server, Client, or NetApp filer.
Add the NetApp filer: Add the NetApp filer as an NDMP Server to the Plug-in for NDMP. For more information, see the Dell NetVault Backup Plug-in for NDMP User's Guide.
Add the backup devices: Add the backup device to the NetVault Backup Server if the device is connected to a filer or NetVault Backup Client. For more information about adding devices, see the Dell NetVault Backup Administrator’s Guide.
Enable UTF-8 encoding: To use UTF-8 encoding, do the following:
Verify that the NDMP service is set to Storage Virtual Machine (SVM)-scoped mode on Clustered Data ONTAP 8.3: On Clustered Data ONTAP 8.3, SMTape backups and restores are only supported in SVM-scoped NDMP mode.
관련 문서