Error with upgrade installation: NetVault is in Safe Mode (4043856)

Return

Feedback Submitted

Did this article solve an issue for you?

Select Rating

Title

Error with upgrade installation: NetVault is in Safe Mode
Description

When upgrading the NetVault Server or a Client, the following error message is displayed:
There has been an error.
Setup has detected that the existing installation of NetVault Backup is in Safe Mode. Upgrade cannot continue while NetVault Backup is in Safe Mode.
Cause

A condition caused NetVault to be on Safe Mode prior to the installation. The situation might have been cleared, but the system was not started on normal mode or there is a safemode.cfg file inside the "config" folder on the NetVault installation directory on the system that is being upgraded.
Resolution

Correct the situation that is causing NetVault to run is Safe Mode.
Deleting the safemode.cfg file will allow the process to continue, but the condition might happen again after the upgrade has completed.
Additional Information

Upgrade, path, there has been an error

Feedback Submitted

Did this article solve an issue for you?

Select Rating

Title