Linux - Configuring the RapidRecovery Agent after install (4040314)

To configure RapidRecovery agent follow these steps:

b. Configure the agent port. The default agent port is 8006. If this port is not ok, you may reconfigure it. Example if you wish to change the default port from 8006 to 8008, do the below:

    1 8008 

    *NOTICE: If Agent was started it will restart after changing port. This may result in interrupted transfer or any other job. Make sure no backup jobs are being run on the agent before changing the port. 

    *NOTICE: The 'root' account is not allowed.

d. Configure firewall rules. If a firewall is enabled in a hint beside step 3 you'll see all methods available to use for configuration. Select one and type:

    3

e. Configure the RapidRecovery agent kernel module. To do so you'll have to select the kernels you desire to install the kernel module in. Type:

    4

   *WARNING* Clean installation does not install RapidRecovery kernel module and agent is not started. RapidRecovery agent cannot function property without the kernel module. So it has to be installed in any kernel you're planning to use. After module installation in current kernel is done agent will start automatically.

    There are 2 options, if the kernel-headers are neither installed nor available in the software repository: 

        b) Find kernel-devel for the obsolete kernel somewhere in the Internet and install it manually. 

f. Start the RapidRecovery agent service. To do so type:

    5