Tchater maintenant avec le support
Tchattez avec un ingénieur du support

NetVault Plug-in for SnapMirror to Tape 10.0.5 - User Guide

Restoring Differential Backups

2
Restore the Full Backup. For more information, see Restore procedure. When restoring the Full Backup, do not select the Break Mirror on Exit check box.
3
Restore the most recent Differential Backup. For more information, see Restore procedure. When restoring the Differential Backup, do not select the Break Mirror on Exit check box
*IMPORTANT: When restoring the Full Backup, if you select the Break Mirror on Exit check box or issue the snapmirror break statement, you cannot restore any Differential Backup.

Using other restore procedures

Renaming a volume during restore

1
Complete Step 1 through Step 3 in the section Restore procedure.
3
In the Restore Rename dialog box, configure the following option:
Rename: Type a new name for the selected volume. You must provide the full path. For example, type /vol/vol1 to rename vol0 to vol1. Verify that the target volume is available on the filer and it is offline.
Click OK to close the dialog box.
4
Complete Step 4 through Step 9 in the section Restore procedure.

Restoring data to an alternate NetApp filer

1
Complete Step 1 through Step 3 in the section Restore procedure.
2
Click Edit Plugin Options, and configure the following option:
NDMP Server: This option specifies the target filer name. By default, it is set to the name of the original filer from which the data was backed up. To relocate the data to an alternate server, type the name of the target filer.
3
If applicable, configure the Break Mirror on Exit option. For more information, see Restore options for Plug‑in for SnapMirror to Tape.
4
Complete Step 5 through Step 9 in the section Restore procedure.
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation