Case in point:
I have applied 2 4.5TB Storage Expansion licenses to one of the appliances. The capacity of the appliance is still showing 4.27TB.
How do I go about seeing further capacity for allocation?
After the key is installed it is required to add it like an enclosure. After you add the license you have to go into storage and add it.
See instructions below.
For more information on this topic, please see the DR Series System Administration 4.0 Web-based Training
Adding a DR Series Hardware System Expansion Shelf
• In the DR Series system GUI, add and activate the expansion shelf enclosure on the Storage page (as described in the steps below).
To add an expansion shelf to the DR Series system, complete the following steps:
The Storage page is displayed. (This step assumes that you have completed all expansion shelf enclosure cable connections and that green LEDs are displayed next to the fastplugs on the rear chassis, indicating that cable connections are active.)
The Enclosure Addition dialog is displayed that indicates that all input-output to the system will be stopped during an enclosure addition, and prompts you to click OK to continue or click Cancel to stop this process.
3. Click OK to continue adding the enclosure to the DR Series system.
A System Status dialog then displays with the following message: The system is currently adding an enclosure. Please wait for this process to complete and the system to become operational.
NOTE: If the Enclosure tab does not display a green status check mark, this indicates that there is an issue with the enclosure (such as it has not been properly connected or activated).
6.After adding an expansion shelf enclosure, make sure that you install an expansion shelf license.
© ALL RIGHTS RESERVED. Feedback Terms of Use Privacy Cookie Preference Center