Chat now with support
Chat mit Support

NetVault Plug-in for SnapMirror to Tape 12.2 - Release Notes

Quest® NetVault® Backup Plug-in for SnapMirror to Tape 12.2

Quest® NetVault® Backup Plug‑in for SnapMirror to Tape 12.2
These release notes provide information about the Quest® NetVault® Backup Plug‑in for SnapMirror to Tape release.

About this release

Quest NetVault Backup (NetVault Backup) Plug‑in for SnapMirror to Tape (Plug‑in for SnapMirror to Tape) provides block-level backups and improved disaster recovery support for data stored on NetApp filers. Working with NetApp SnapMirror technology, the plug-in lets you back up selected volumes or snapshots to tape devices for off-site storage. The GUI gives you a single, centralized console to configure backup and restore policies for all your NetApp filers.

Plug‑in for SnapMirror to Tape 12.2 is a minor release, with enhanced features and functionality.

Enhancements

Added support for NetApp Data ONTAP Release 9.5.

DNSTP-143

Resolved issues

Corrected an issue in which restores that span tapes failed with the following error: “SMTAPE: Bad block in read stream. vbn = xxxxxxxxxx, max_vbn = xxxxxxxxx”

DNSTP-55 (13506, NTG‑60)

Corrected an issue with NetApp Data ONTAP 8.1.7 Mode filers in which the plug-in restored data correctly, but reported the job status as failed and generated a dump.

DNSTP-64 (13515, NTG‑69)

Corrected an issue that caused a backup job to stop responding when the starting slash was omitted from the backup path.

DNSTP-105 (29586)

Corrected an issue that caused a backup job to stop responding if you used an ndmpd kill command to terminate the NDMP sessions.

DNSTP-106 (29721)

Corrected an issue that caused a backup job to fail if the main volume was selected and any Vservers and volumes were excluded. To omit items from a backup job, clear the corresponding check box. The plug-in then displays an X for the selection item.

DNSTP-130

Corrected an issue in which selecting the Delete Previous Snapshot option or Delete All Previous Snapshots option, or both, with a Block Level Incremental (BLI) backup did not delete previous snapshots.

DNSTP-132

Self-Service-Tools
Knowledge Base
Benachrichtigungen und Warnmeldungen
Produkt-Support
Software-Downloads
Technische Dokumentationen
Benutzerforen
Videoanleitungen
RSS Feed
Kontakt
Unterstützung bei der Lizenzierung
Technische Support
Alle anzeigen
Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen