Uninstalling Metalogix StoragePoint.
This section will walk through the process of removing an existing Metalogix StoragePoint installation. For installation steps, see the Metalogix StoragePoint Quick Start Guide.
WARNING: Removing Metalogix StoragePoint from a farm where content is externalized will leave that content irretrievable. Therefore, recall content for all active Storage Profiles and deactivate the EBS Provider, if applicable, before removing Metalogix StoragePoint from the SharePoint farm. See the Deactivating the EBS Provider section of the Reference Guide for more information.
NOTE: StoragePoint must be present to allow for continued management of Large File content through SharePoint. Please see Large File Support in the Reference Guide for more information.
1.Launch the Metalogix StoragePoint Installer. Click Start Installing.
3.Click OK to begin the StoragePoint retraction.
4.The configuration wizard opens. Click Next.
5.The installer will now perform a series of system checks to make sure the system is ready for Metalogix StoragePoint to be modified. If all system checks pass click Next.
NOTE: If a system check fails it will be denoted with a red X and the install will not be able to continue until the issue(s) are resolved. The installer will also check whether the most recent supported SharePoint CU is installed.
The solution file will now be removed from all servers in the farm. This process can take upwards of 5 minutes depending on the size of the farm.
7.Upon completion of the uninstall process the progress status will change to All operations successfully completed. Click Next.
8.The uninstall process is complete. Click Close.
9.The Installation wizard will complete the uninstall. Click Finish.
10.Close the Install Wizard by clicking Quit in the bottom left, and Yes on the prompt.
© 2021 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz