Zurück
-
Titel
How to create a new bond? -
Beschreibung
How to create a new bond?
Need to create a new bond.
-
Lösung
First confirm the ports show available. This can be done with a "network --show".
Once we know the ports to use, we can create the new bond through the "network --create_bond" command:
--create_bond --bondif <bondN>[--dhcp][--static]--nwif <eth0,eth1,...,ethN>[--mode < ALB | 802.3ad>][--name < DNS name >][--mtu <Supported MTU range 512 - 9000>][--ip <IPv4/IPv6 address not already in use>][--netmask <netmask>][--gateway <IPv4/IPv6 address>][--restart]--bondif Bond interface to create.--dhcp Create dhcp interface.--static Create static interface.--nwif Eth interfaces to bond.--mode Bonding mode to use.--name DNS name for the interface.--mtu Ethernet MTU to use (valid range is 512 - 9000).--ip Static IP address to use.--netmask Netmask for the static IP address.--gateway Gateway for routing.--restart Restarts networking after creation.For example, to create bond1 using eth3 and eth4, run the command:
network --create_bond --bondif bond1 --dhcp --nwif eth3,eth4 --mode ALB --restart
-
Weitere Informationen
https://support.quest.com/technical-documents/dr-series-software/4.0/command-line-reference-guide/14#TOPIC-647360