立即与支持人员聊天
与支持团队交流

InTrust 11.6 - Preparing for Auditing TPAM

Step 5. Establish a Connection with InTrust Server

To establish a connection between an agent and an InTrust server, see the procedure in the Establishing a Connection with the Server topic.

Step 6. Add Agent to Site on InTrust Server

To add agent to site on InTrust Server, take the following steps:

  1. In Quest InTrust Manager | Configuration | Sites | Unix Network, right-click the TPAM hosts node and then click Add | Computer.
  2. Type in the name of agent previously installed on step 4.

Note: To view agents registered for this InTrust server, open Quest InTrust Manager | Configuration | InTrust Servers | <Server Name> | Agents node in the left pane.

  1. Click Commit on the toolbar to apply changes.

Step 7. Enable Schedule for Daily Collection Task

To enable the schedule for the daily collection task, take the following steps:

  1. In Quest InTrust Manager | Workflow | Tasks | Predefined tasks, right-click TPAM Syslog - daily collection and select Properties.
  2. Select the Schedule enabled check box and click OK.
  3. Click the Commit button on the toolbar to apply your changes.

Step 8. Run Daily Collection Task

To start collecting events that the Linux host receives from the TPAM appliance, right-click Syslog - daily collection in the left pane and then click Run.

This task collects all events from TPAM appliance and stores the events in the default repository. To view current state of the task, use the Workflow | Sessions node in the left pane.

When daily collection task is finished, you can open InTrust Repository Viewer and start processing event data according to your needs. For possible use case scenarios, follow information from the Usage Scenarios topic.

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级