To send notifications by email, you must configure the Outgoing Email Server (SMTP) settings. You can configure the SMTP settings from the Change Settings page.
1 |
In the Navigation pane, click Change Settings. |
2 |
Under User Interface, click Notification. In the Notification dialog box, under Mail Server, configure the following options. |
Specify a user account that can be used for SMTP authentication. This option is only required if the Perform Authentication check box is selected. If no user account is specified, the user name from NetVault’s E‑mail Address is used for authentication. For example, if you specify “User-A@mycompany.com” in the NetVault’s E‑mail Address box, NetVault uses “User-A” to perform SMTP authentication. | |
Select this check box to use the Fully Qualified Domain Name (FQDN) instead of nvsendmail with the EHLO and HELO commands. NetVault uses the host name in mail server messages, so the system must be set up with an FQDN to display the host name in FQDN format. |
3 |
Click Apply to apply the new settings and close the dialog box. |
To use the Sysop Email notification method, you must configure the SysOp email address. You can configure the email address from the Change Settings page.
1 |
In the Navigation pane, click Change Settings. |
2 |
Under User Interface, click Notification. In the Notification dialog box, under Global Notification, configure the following settings. |
3 |
Click Apply to apply the new settings and close the dialog box. |
To use the Print Report method on Windows, you can either configure a default printer or set the variable NVPRINTER while setting up a notification method. You can configure the default printer from the Change Settings page.
1 |
In the Navigation pane, click Change Settings. |
2 |
Under User Interface, click Notification. In the Notification dialog box, under Default Printer, configure the following setting: |
• |
Default Printer Name: To configure a default printer for the Print Report notification method, type the printer name. Specify the exact string that is used to identify the printer in the Windows OS. |
3 |
Click Apply to apply the new settings and close the dialog box. |
Before you can use SNMP Trap method, you must configure the network manager host settings. You can configure these settings from the Change Settings page.
1 |
In the Navigation pane, click Change Settings. |
2 |
Under User Interface, click Notification. In the Notification dialog box, under SNMP Traps, configure the following settings. |
3 |
Click Apply to apply the new settings and close the dialog box. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. 使用条款 隐私 Cookie Preference Center