サポートと今すぐチャット

オンラインヘルプの参照
登録の完了

サインイン

価格設定をリクエスト

営業担当に連絡

Change Auditor - For Advanced Users 7.0.3 - SCOM Management Pack

コンテンツのナビゲーション

SCOM Management Pack Overview

Configuration Requirements Knowledge Authoring — Purpose Knowledge Authoring — Features Knowledge Authoring — Configuration

SCOM 2012/2012 R2/2016 Management Pack Design

Change Auditor Target Change Auditor Installation Object Discovery Alert Views

Knowledge Authoring — Configuration

No special configuration is required for this management pack. The Change Auditor components are set up so that the management pack rules automatically deploy to any computer that is running a properly installed and registered instance of the Change Auditor coordinator.

SCOM 2012/2012 R2/2016 Management Pack Design

This section provides the implementation and configuration specifics of the various components of the Change Auditor Management Pack for SCOM 2012, 2012 R2, and 2016.

•

Change Auditor Target

•

Change Auditor Installation Object Discovery

•

Change Auditor Target

The following SCOM type is supported with the Change Auditor Management Pack:

•

Quest Change Auditor Installation

This SCOM type identifies which agents are intended to run the Change Auditor rules.

To view a list of all the Change Auditor rules associated with this SCOM type, open the Rules folder of the Authoring pane in the SCOM Operations Console.

Change Auditor Installation Object Discovery

The following SCOM Object Discovery is supported with the Change Auditor Management Pack:

•

Quest Change Auditor

This attribute locates the servers that are running Change Auditor coordinators.

The attribute reflects the existence of the following Registry Key, whose presence indicates a properly installed and registered instance of the Change Auditor coordinator: SOFTWARE\Quest\ChangeAuditor\Coordinator\Path

関連ドキュメント

The document was helpful.

評価を選択

I easily found the information I needed.

評価を選択

© ALL RIGHTS RESERVED. Feedback 利用規約プライバシー Cookie Preference Center